![]() ![]() When two devices share the same data ribbon cable in a system that doesn't support "Cable Select," the device at the end connector of the ribbon cable is configured as "master," while the device connected to the middle connector is configured as "slave." Your optical drive likely has its configuration jumper installed as "master," so the Zip drive should have the small plastic jumper installed across the pins marked "slave." Do you primarily have 100 MB Zip disks or a mixture of 250 MB and 100 MB disks? The reason I'm asking is to determine if you've already acquired the Zip 250 drive or would prefer a Zip 100 drive? A Zip 250 drive can read and write both Zip 250 and Zip 100 disks, but erasing/reformatting a Zip 100 disk in a Zip 250 drive with the IomegaWare software takes a long time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |